Server status =>
Enter the blue ID into the ID field of the Client page and click [Connect] in the Client
Starting the Server & Client
1. Refresh this Server page so it starts off not connected to the ZachTek. Do not open the serial port yet.
2. Connect the Client page: enter the blue Server ID into the ID field on the Client page and click [Connect].
3. From this Server page choose and open the serial port (browser security prevents other IPs choosing and opening ports).
4. The Client must be connected before opening the port or it won't update itself from the ZachTek hardware.
Note: a new ID will be generated each time the Server page is refreshed or reloaded in the browser.
Scheduler info
1. Click [TX Off] to set WSPR mode to idle.
2. Click in the matrix to turn band hours on and off.
3. Click [schedule on] to start beaconing.
- hours in the scheduler are YOUR LOCAL TIME to make grey lines easy to use.
- you can change the matrix hours while the schedule is running. No need to click [schedule on].
- the schedules can't be stored in the Zac and will run only while this page is active.
selection quickie: click a blue band or hour label for a whole row or column. Use the menu for saving Scheds.
ZachTek info
1. Connect your ZachTek 80-10 desktop device to your computer via USB cable
2. Click the [open serial] button and select your ZachTek
- you should then see data being transferred and the stored ZachTek settings appear
3. Proceed as per normal ZachTek operation:
- enter new or change any existing settings
- click the bands of choice in the enable column
- select [TX On] to start the WSPR beacon cycle on the next even 2 minute slot
5. Click [Save settings] to permanently store changes in the ZachTek
- if you close the page the ZachTek will keep operating in its saved state
6.
[Aug 11th update] Feedbak to vk7jj at me dot com
73, Phil VK7JJ